LED R&D Lab(VD)
14
1. Product Information and Installation Precautions
◆ Heat protection guide
Requirements for indoor installation
- Applicable to use of SAMSUNG wall mount (compliant with ADA)
∙ Gap between the product front and the wall: 99.5 mm
∙ Gap between the product rear and the wall: 35.5 mm
- Entry of sunlight
∙ If sunlight enters through glass windows or outer walls of the building,
contact Company HQ for assistance.
- Cold/warm air from HVAC system
∙ Make sure cold or warm air (especially warm air) from an HVAC system
does not reach the product.
- Outdoor temperature measurement position
∙ Center of the product or the inlet area
※ ADA: Americans with Disabilities Act
99.5 mm
35.5 mm
wall
Outdoor temperature
measurement position
Outdoor temperature
measurement position
※ This page is written based on the Full white,
650 nit (back light 7) version
To Next Page
Loading...
