LED R&D Lab(VD)
44
6. S-Box Installation and Connection
• S-Box connection
① Send visual signal input into the S-Box (input ports: HDMI, DP).
② Use the SOURCE STATUS to check the signal input (Red: HDMI1, Green: HDMI2, Blue: DISPLAY PORT).
③ Use the LAN cable to connect the HDBT OUT port on the S-Box to the HDBT IN port on the Interface Gender.
④ Use the OCM cable to connect the DATA OUT port on the Interface Gender to the DATA IN port on the first cabinet.
⑤ Please add input signal with “Input signal Plus” menu for UHD resolution
※ Menu – Picture – Advanced Settings – Input signal plus : add input signal
(The default setting is OFF. If this setting is changed, the S-Box is rebooted.)
⑥ The screen is displayed based on the cabinet in the top left.
To view the screen, connect to the HDBT OUT1 port on the S-Box.
⑦ For each S-Box, the same type pitch cabinet can only be supported
simultaneously. When installing the product, only connect
compatible cabinets to the product.
To Next Page
Loading...
