Samsung IER Series

LED R&D Lab(VD)
27
2. Preparation for Cabinet Installation
⑧ For cabinets placed on the edge, attach PET sheet before attaching PCB covers.
※ Attach PET sheet to all borders of the LED module (Fig.1), and attach PCB covers to the same outer sides where the
PET sheet has been attached (horizontally 5 points and vertically 4 points, as shown by the blue borders in Fig.2).
※ Attach PET sheet as shown in Fig.3. Make sure the area with no tape guides the LED module.
※ Attach PCB covers as shown in Fig.4.
Fig.2 Borders requiring PET sheet and PCB covers
* Numeric figure: Quantity of PCB covers to attach
Fig.3
Fig.4
PET sheet
No tape
0 to 0.5 mm
Fig.1 Attach PET sheet here
Fig.1 Attach PET sheet here