LED R&D Lab(VD)
26
⑥ Connect the power cord that came with the product and turn on the product.
Check that there is no LED damage and no problem is found on the screen.
※ Steps to perform in the event of White Pattern
- Apply power and press and hold the Switch for 5 seconds.
- When the factory info window appears, press the Switch once again.
- When the color screen appears, press the Switch repeatedly to check for malfunctioning LEDs.
(Each time the Switch is pressed, the LED color is switched in the following order:
white → blue → red → green.)
- To turn off the mode, press and hold the Switch for 5 seconds again.
2. Preparation for Cabinet Installation
◆ Note: Checking for a screen problem
Switch (Toggle)
Power In
Power out
To Next Page
Loading...
