LED R&D Lab(VD)
113
2-5. IER-F + IER-F L-Type Installation
• When IER-Fs are stacked upward, fasten the Bracket Align that is used to compensate for Z-axis difference between top and bottom cabinets.
• Remove the bottom module from the upper cabinet and the top module from the lower cabinet.
• Pass the Bracket Align through the hole of the Cover Rear from the top to connect the up and down cabinets and fasten them with screws.
• Connect the modules again.
* Apply Bracket Align for L-type and all IER-F cabinets that are connected vertically.
Fig 29. IER-F Bracket Align Installation Procedure
Bracket Align
(included in the Set)
BRACKET-LINK
To Next Page
Loading...
