LED R&D Lab(VD)
51
6. S-Box Installation and Connection
• S-Box connection (Panel configuration)
① Initial S-Box picture quality settings
• S-Box is delivered with default picture quality settings optimized for the IWJ cabinet.
• After an LED display is installed, the picture quality settings become automatically optimized for the installed LED display model.
• To ensure configuration of optimum picture quality settings, make sure you use the LSM SW to connect the S-Box to the LED display.
• Make sure the LED display is connected to HDBT Port 1.
• Picture quality settings are configured based on the master cabinet model connected to HDBT Port 1.
* If the S-Box is not connected to the LED display via LSM, displayed colors may not look natural.
<Connection screen>
Control PC
(LSM)
S-Box
Ethernet
Interface Gender
Vx1
……………
HDBT
Vx1+Ethernet
Cabinet 1
(Master)
Cabinet N
To Next Page
Loading...
