LED R&D Lab(VD)
61
※ Note : Before update, disconnect the Multi Link HDR Cable from S-BOX.
• FPGA Update Guide when using Multi Link HDR Cable
Factory update method
① Save a SW program called ‘TB-XCKUSBMWWS.bin’ in
USB root.
② Connect the USB to S-BOX.
③ Enter Factory mode.
(Remote control ‘mute +1+8+2+Power ON’ in power off state)
④ Select “SVC → UPGRADE” menu.
⑤ Move the cursor to “FPGA UPGRADE” menu.
⑥ Press ‘Enter’ in the remote control.
⑦ Press ‘▶’ button in remote control to start the upgrade.
LSM update method
① Select ‘S-BOX Settings – Software Update’ in LSM menu.
② Select ‘Browser’ and move to the folder with the FPGA update file
(TB-XCKUSBMWWF.bin + Info.txt) ※ Version in ‘Info.txt’ file should
be higher than currently installed version
③ Select ‘TB-XCKUSBMWWF.bin’ file.
④ Select ‘Update’ button to start the upgrade.
※ Note : In case of the sites that are difficult to remove the Multi Link HDR cable, all connected S-BOX should be AC power off/on
after LSM update done. (Must turn off AC power after the update of all S-BOX are completed)
Check the version of FPGA after update.
6. S-Box Installation and Connection
(No support for SBB-SNOWJAU or below models)
Multi Link HDR Port
To Next Page
Loading...
