LED R&D Lab(VD)
85
※ For AM3352, update files for LSM and USB are different.
※ A separate tool is required to update the FPGA SW to USB.
① F/W update via USB
1. Prepare the items below.
- USB memory formatted in FAT32 format
- Copy files for updates to the USB root folder
2. Disassemble the back cover of the Cabinet and insert the USB memory into
the TCO Board.
- Located at the bottom right of the T-CON board (USB terminal)
3. Press and hold the toggle switch on the top of the TCO Board and turn it on.
- Press and hold and turn on AC power
- Press the switch for 4 seconds after AC power is turned on to proceed with
the update.
4. Check the Cabinet Info by entering the test pattern after power loss.
- See page 15 on how to enter the test pattern
7-2. SW Update
7. Settings / How to Use
To Next Page
Loading...
