Samsung NX300 - Page 67

Firmware update
7-8 Copyright ⓒ since 1995 Samsung Electronics. All rights reserved.
Fig. 7-12
6. Press the OK button to begin the body rmware update. Once it is complete, camera will turn off automatically.
[CAMERA]
- User Version : 0.51
- Full Version : nx300_DSP_X_PV1_F1301261
[SD-CARD]
- User Version :
- Full Version :
[H/W]
- Board Version : PV2 / Micom Version : -1
FW update by pressing the [OK] key.
OK button
CAUTION
!
■ Firmware update will take about 5 minutes. It will reboot twice during the rmware update process.
Screen seems to be turned off. However, do not turn off the camera or operate camera.
Once the update is complete, it will display update complete message on the screen.