4. Double click the “USBSet1.1.exe” to execute.
1) Connect the USB cable from your camera to the USB port on your computer when below window appears.)
(Make sure the “info.tgw” file is into SD card. )
Fig. 8-6
2) When below window appears, turn on the computer and check the USB directory’s path.
Click the “Regist channels” button and then click the “OK” button.
Fig. 8-7
3) Turn off the camera and then exit the USBSet1.1.exe.
5. Double click the “NXShutterTester.exe” to execute
.
1) Connect the RFS-500 measuring equipment and your computer with USB cable. Turn on the RFS-500.
Right click on “My Computer” and click the “Manage”, and then click the “Device Manager”.
The Device Manager opens as shown in Figure below. Check the connection status of the “COM” to the “Device Manager”.
PORT
q
w
e
To Next Page
Loading...
