English English _ 21
INSTALLING YOUR CAMERA
Communication Response Settings
Select a communication response method for the camera and controller: Response or
No Response.
Function ON OFF
SW2- #7 Response Mode Switch Response No Response
Termination Settings
To prevent the attenuation of communication signals between the camera and
controller, the items at the end of line must be set up with the termination settings.
Camera Input Position SW2- #8
Termination of Longest Path ON
On the Path OFF
This model is provided with factory defaults of all DIP switches set to OFF. The default
settings are shaded in the table.
To use a third party controller with this product, please contact our After-Sales Service
or Technology Department.
Controls Using Different Protocols
AD Protocol VICON Protocol GE Protocol
Entering Camera OSD
3+Auxilary ON IRIS OPEN IRIS OPEN
Exiting Camera OSD 3+Auxilary OFF IRIS CLOSE IRIS CLOSE
ENTER IRIS OPEN IRIS OPEN IRIS OPEN
ESC IRIS CLOSE IRIS CLOSE IRIS CLOSE
ö
Control with the SSC-5000 Controller
Protocol Enter Esc
Samsung-T Focus Far Focus Near
Samsung-E Iris Open/Focus Far Iris Open/Focus Near
Note that LCD monitor does not switch to OSD mode and the Joystick will not provide
Enter operation, when using the OSD menu with Samsung-E protocol.
CAMERA ID DIP SWITCH SETTINGS (SW1)
To set up camera IDs, refer to the “Camera ID Chart” next.
❖
❖
*
M
ON
ON
OFF
SW1
To Next Page
Loading...
