English English _ 41
INSTALLING YOUR CAMERA
Secure the safety wire (attached to the product) to the housing as shown. (For details
about the cable connection, refer to the "Camera Wiring Interface Board" section in this
manual.)
Arrange the cables inside the housing lest they be damaged or stuck in, and use the L-
shaped wrench to tighten 4 screws to the housing. To ensure waterproofness, this step
needs your special care. Otherwise, the gasket on the outer side of the product may be
loose or just stuck in.
3.
4.
GASKET
HOUSING
MAIN-FRAME
SCREW
SAFETY WIRE
SAFETY WIRE
To Next Page
Loading...
