After finishing setup, press [Execute] in the parent menu to activate the Group
SEQ mode. (Or turn OFF OSD Menu, and then press [Group]+[Group Number]
using the controller.)
When Group SEQ is activated, the camera starts auto tracking at the [Preset 1]
location. For the set DWT duration, the camera performs Auto Track according
to [Auto Release] and [Auto Return] settings. If no movement is detected, it
moves to [Preset 2] and repeats the procedures.
1. Setting Target Lock
▶
Main Menu/P/T Settings/Auto Track2
2. Target Lock
Start
Group SEQ
[Auto Release]
(10sec~5min)
[Preset 1] [Preset 2] [Preset N]
Start
Tracking
Next
Preset
Last
Preset
Finish
Tracking
[ Lost Mode ]
Performed only for the Auto
Release Duration
[ Auto Return ]
(1sec~5min)
<Group SEQ Timing Chart>
Auto Tracking Using Target Lock
Auto Track 2
①Zone Setting
Indicator OFF
Target Lock OFF
Target Lock => [ON]
- When Target Lock is turned [ON], a red box
appears in the center of the screen.
Using the joystick, move the red box to encircle
an object and then press [Enter] to start Auto
Tracking the object.
P:234 T:5 1x
Setting Up Auto Track
To Next Page
Loading...
