32_ operating
Max Cleaning
The vacuum cleaning robot automatically moves and cleans until
the battery runs out and the battery level fl ashes only one level.
If cleaning begins when the vacuum cleaning robot is docked with
■
the charger station, the time to return to the charger is decreased
since the vacuum cleaning robot remembers its original position while
moving.
If the vacuum cleaning robot starts the current cleaning run at
■
a location other than the charging station and fails to locate the
charging station while cleaning, it will stop near the location where it
started cleaning.
If the battery level becomes low while cleaning, the vacuum cleaning robot automatically returns
■
to the charger station and resumes cleaning after charging the battery. (Number of resumed
cleaning operations: Once)
Main unit button
Remote control
button
Confi guration
Sequence
Normal Mode
Turbo Mode
Dust Sensor Mode
3time
▶
2 times in charging mode
Set the mode.1.
Cancel the mode.2.
About the Resume Cleaning function
If the vacuum cleaning robot judges cleaning to be •
complete, resume cleaning is not performed.
If you move the vacuum cleaning robot while it is being •
charged or press a button, vacuum cleaning robot judges
cleaning to be complete (cleaning is not resumed).
Do not move the vacuum cleaning robot while it is cleaning •
or press a button while cleaning. Otherwise, the vacuum
cleaning robot judges cleaning to be complete and starts
cleaning again from the beginning.
Each time you press the Turbo button, the Turbo icon on •
the display panel is turned on or off sequentially. When the
Turbo icon is turned on, you can start cleaning in Turbo
mode.
Each time you press the Dust Sensor button, the Dust •
Sensor icon on the display panel is turned on or off
sequentially. When the Dust Sensor icon is turned on, you
can start cleaning in Dust Sensor mode.
NOTE
CAUTION
DJ68-00632D(0.0).indd 32DJ68-00632D(0.0).indd 32 2012.1.19 9:50:39 AM2012.1.19 9:50:39 AM
To Next Page
Loading...
Need help?
General
