20_ operating
INSTALLING THE VACUUM CLEANING ROBOT
Installation order
Turning the Power Switch on or off1.
To use the vacuum cleaning robot, you must turn on the Power Switch
at the bottom of the main unit.
Installing the Charger2.
To charge the vacuum cleaning robot, you must fi rst install the charger.
Since the battery is discharged when the product is purchased, you
must fully charge the battery before use.
Charging the Battery3.
You should charge the battery completely before using the vacuum
cleaning robot.
Setting the Time4.
You should set the time to use the scheduled and daily cleaning options.
Installing the VIRTUAL GUARD5.
You can confi ne the vacuum cleaning robot to a particular section by using Fence (virtual wall)
mode.
Turning the Power Switch on or off
To use the vacuum cleaning robot, you must turn the Power Switch
on.
If you turn off the Power switch, all settings except for the current
time and the Weekly reservations are reset.
Lift the body and turn on the power switch while making 1.
sure not to press any other button.
If the icons are not turned on, it indicates that the battery charge -
is depleted. In this case, dock the vacuum cleaning robot to the
charger station after turning the Power Switch on.
The confi gured time may be different from the current time. If the -
confi gure time is incorrect, set the time to the current time.
If the Power Switch is turned off, the vacuum cleaning robot will
not be charged even if it is docked with the charger station.
operating the cleaner
CAUTION
DJ68-00632D(0.0).indd 20DJ68-00632D(0.0).indd 20 2012.1.19 9:50:25 AM2012.1.19 9:50:25 AM
To Next Page
Loading...
Need help?
General
