DHCP Server
You can set the internal DHCP server and assign an IP address to the network camera.
[MENU] [ENTER] ▼ <Menu> [ENTER] ▼ <Network> ►▼ <DHCP Server>
[ENTER] ▼ <Network> ▲▼◄► [ENTER]
Network Setting
•
Network 1 (Camera) / Network 2 (Viewer) : Select <Setup>, and you can set the IP range operated by the
server and time.
To set the DHCP server
1. On the DHCP Server Setup window, click <Setup>.
2. Select <Run> in the <Status> field.
3. Enter the starting IP and end IP in the <IP Range> field.
4. Fill in the <IP Lease Time> field.
5. Click <OK>.
The IP range entered is set as the DHCP server address of the network.
Check IP
You can check the IP Address and Mac currently used through the DHCP server, and the connected network
port.
[MENU] [ENTER] ▼ <Menu> [ENTER] ▼ <Network> ►▼ <DHCP Server>
[ENTER] ▼► <Check IP> [ENTER] ▲▼◄► [ENTER]
•
Network : Select the network port to check the information on IP and others.
To Next Page
Loading...
