SETTING THE DEVICE
You can setup Camera, Storage Device and Monitor.
Camera
To register a camera
You can register a network camera for each channel and make connection between.
[MENU] [ENTER] ▼ <Menu> [ENTER] ▼ <Device> ► <Camera> [ENTER] ▼
<Cam Registration> ▲▼◄► [ENTER]
•
Preview : View the video of the channel as a current image.
•
Protocol : Show the protocol information of a registered network camera.
•
Model : Show the camera model name.
•
IP Address : Display the IP address of a network camera.
•
Connection : Display the connection status.
•
Data Rate : Displays the total amount of data received by the channel.
•
PoE Status : Displays connected PoE status information.
•
ONVIF Setup : You can additionally set up ONVIF protocol camera.
•
Error code guides : You can check the details of generated error codes.
M
` If the NVR has been initialized, it may not connect to cameras. Configure the network settings first and add cameras.
For more information on network settings, refer to "Network Configuration". (Page 97)
To Next Page
Loading...
