English _35
● LIVE
Install Wizard
As shown below, proceed through each step of the <Install Wizard>.
1. In the <Language> screen, select the language and press
the <Next> button.
2. In the <ID/PW> screen, set the password and press
<Next>.
M
` If you click < >, a basic guide for password setup is
displayed.
3. In the <Network> screen, set the network access method
and the access environment. To use a simple intranet, click
<Next>.
• Network 1 (Camera) : Connects to the camera and receives the video feed from the camera
• Network 2 (Viewer) : This is a port for transmitting an image to the webviewer.
• Network 1 / Network 2 Setup
- IP Type : Choose the network connection method.
- IP Address, Subnet Mask, Gateway, DNS
M
` If the LAN cable is not connected to the port, the setting button will not be activated for use. Check the LAN cable
connection.
` The built-in DHCP Server in NVR will turn on automatically at stage 3. At this stage, using the existing DHCP server in the
same network may cause a problem, as two DHCP servers would be simultaneously operating.
` For more details on network settings, refer to the user manual.
4. After setting the date/time settings in the <Date/Time>
screen, click on the <Finish> button to launch the setting
completion window.
5. In the setting completion window, click on the <OK> button
to finish camera setting and launch the camera registration
screen.
To Next Page
Loading...
