What to do if my Samsung SRV-940 remote control does not work?
If the remote control isn't working, first check and replace the battery if needed. Ensure you're pointing the remote directly at the unit's receiver. Also, verify that the unit ID and the remote control ID match, and if not, set them to the same ID.
What to do if Samsung SRV-940 remote control does not work?
If your Samsung DVR remote control isn't working, try these steps: First, check the battery and replace it if needed. Second, make sure you're pointing the remote directly at the unit's receiver. Finally, ensure that the unit ID and the remote control ID match, and set them to the same ID if they don't.
Why is scheduled recording not working on my Samsung SRV-940?
If your Samsung DVR isn't performing scheduled recordings, check that the Scheduled Recording Start/End times and the current time are set correctly.
Why is there no audio in my Samsung SRV-940 recorded video?
If there's no audio in your recorded video, check whether [AUDIO] in [RECORD SETUP] of the Menu is set to [OFF]. Also, verify the volume setting of the CCTV monitor.
Why are images not appearing on my Samsung DVR monitor?
If images are not appearing on the monitor, verify that the video output is correctly set to BNC or VGA using the dip switch at the rear of the unit. Also, check the camera connection to the input terminal and ensure the monitor's brightness is appropriately adjusted.
What to do if my Samsung DVR is not performing Scheduled Recording?
If your unit isn't performing scheduled recordings, verify that the scheduled recording start and end times are set correctly, and that they align with the current time.
Why is there no audio in my recorded Samsung SRV-940 DVR video?
If there's no audio in your recorded videos, check whether the [AUDIO] setting in the [RECORD SETUP] menu is set to [OFF]. Also, check the volume level of your CCTV monitor.
What to do if my Samsung SRV-940 DVR HDD recording is not performed?
If HDD recording is not being performed, the service life of the HDD may have ended, or there may be bad sectors on the HDD. In these cases, replace the HDD.
How to fix unclear monitor screen on Samsung DVR?
If the monitor screen is not clear, check whether the camera's focus is properly adjusted.
General| Channels | 4 |
|---|---|
| Hard Drive Capacity | 1TB |
| Video Compression | H.264 |
| Remote Viewing | Yes |
| Motion Detection | Yes |
| Alarm Inputs | 4 |
| Operating Temperature | 0°C ~ +40°C |
| Power Supply | DC 12V |
To Next Page
