Monitor Output (VGA)
This is the output connector for a VGA Monitor.
SVR-940
SVR-450
SVR-940
No. Description No. Description
1 TX+(Transmit Data) 5 N/C(No connection)
2 TX-(Transmit Data) 6 RX-(Receive Data)
3 RX+(Transmit Data) 7 N/C(No connection)
4 N/C(No connection) 8 N/C(No connection)
Chapter 4. Operating
No. Description No. Description
1 Red Signal (75, 0.7Vp-p) 9 N/C(No connection)
2 Green Signal (75, 0.7Vp-p) 10 Ground
3 Blue Signal (75, 0.7Vp-p) 11 Ground
4 N/C(No connection) 12 N/C(No connection)
5 Ground 13 HSYNC (Horizontal Synchronization)
6 Ground 14 VSYNC (Vertical Synchronization)
7 Ground 15 N/C(No connection)
8 Ground
4.1 Checklist before operation
Users must select the video mode (NTSC or PAL) and video output (BNC or VGA) before powering the
system on. These can be selected from the switches on the rear of the DVR system.
The settings of the video mode and video output are as described below.
SETTING
Video mode Video output
NTSC PAL BNC VGA
O X O X
X O O X
Chapter 3. Installation Chapter 3. Installation
To Next Page
Loading...
