* The factory default is set to NTSC video mode and VGA video output.
SETTING
Video mode Video output
NTSC PAL BNC VGA
Factory Default
O X X O
X O X O
4.2 Power connection
4.3 Live monitoring screen
· After power is connected to the rear connector of the system, the system will be powered on.
· When power is turned on, the system will detect a video signal automatically.
· Despite of a power failure, all the setting values will preserve.
When the system is turned ON, the live monitoring screen is displayed.
When Channel number buttons 1 ~ 4 (SVR-450) / 1 ~ 9 (SVR-940) are pressed, each channel is dis-
played in full screen.
When the AUTO button is pressed in each full screen mode, each channel is rotated automatically
following the setting in [SCREEN SETUP] > [Auto Sequence]. (SEQUENCE must be set to [YES].)
When AUTO is pressed again, the Auto sequence operation will be canceled.
Press the ENTER button, and the four connected channels are displayed in quad split screen
4.3.1 Function of screen display
4.3.2 Automatic channel rotation
Chapter 4. Operating
Chapter 4. Operating
To Next Page
Loading...
