English _71
● MENU SETUP
If you want to register a camera in PnP mode
J
` When you connect a camera in PnP mode, the initial ID, password and DHCP mode should be set in advance.
` Samsung cameras are registered for Samsung protocols and other cameras are registered by using the Onvif protocol.
` In PnP mode, you cannot connect a device that runs the DHCP server in PoE port or camera setting port. (Ex: hub)
To auto-search for and register a network camera
1. In the <Cam Registration> field, click on the <Auto> button.
2. Search for a network camera connected.
` An already registered camera will be marked in blue in the list.
` If you search for the camera again or if the IP is an old IP that was not assigned by the DHCP server (such as -192.168.1.100),
then press the < > button to check if a new IP has been assigned. If the IP is still the same, then select Assign IP to assign
the IP manually.
3. Select a camera from the camera list to see a preview of its current video feed.
` Camera searched with ONVIF does not provide previews.
To Next Page
Loading...
