English _25
● INSTALLATION
4. Align and insert HDD into the bracket home. After
inserting one side, push and insert the other side
slightly.
5. Align the bracket with the HDD installed with the
enclosure latch, and push the bracket in the direction
of the board.
J
` Push it until you hear the latch lock sound. If the HDD is
not completely connected, it may be detected.
6. Push the front cover upwards and close it.
• How to exchange an installed HDD
1. Open a bracket wide in the direction of the arrow and
remove the holder from the HDD.
2. Open the other bracket wide and remove it from the
holder.
M
` The procedure after HDD exchange is the same as the
procedure for "Installing the HDD".
To Next Page
Loading...
