Problem Possible Solution
Ghosting on p_cture. This is sometimes caused by compatibility issues with your
cable box.
Try connecting Component cables instead.
Screen is black and power indicator On your computer check: Power, Signal Cable.
light blinks steadily. The TV is using its power management system.
Move the computer's mouse or press any key on the
keyboard.
Image is not stable and may Ifthe setting is not correct, use your computer utility
appear to vibrate when you have program to change the display settings.
a computer connected to the PC Your TV supports multiscan display functions within the
input following frequency domain:
- Horizontal frequency (kHz): 30~81 (P237OHD),
52.61~82.2 (P2570HD)
- Vertical frequency (Hz): 56~75 (P2370HD), 48~75
(P2570HD)
- PC Maximum refresh rate (at 60 Hz): 1920 x 1080
Image Is not centered on the
screen.
The picture appears distorted in the
corner of the screen.
The 'Resets all settings to the
default values.' message appears.
Adjust the horizontal and vertical position.
The screen position must be adjusted on the output source
(i.e. STB) with a digital signal.
If"Just Scan" is selected with some external devices, the
picture may appear distorted in the corner of the screen.
This symptom is caused by the external devices, not TV.
This appears when you press and hold the EXIT button
for awhile. The product settings are reset to the factory
defaults.
This TFT LCD panel uses a panel consisting of sub pixels (6 220 800) which require
sophisticated technology to produce. However, there may be few bright or dark pixels on the
screen. These pixels will have no impact on the performance of the product.
To Next Page
Loading...
