Troubleshootingfor Anynet+
eroblem ....F_o&_ solution .........
Anynet + does not work. • Check if the device is an Anynet + device. The Anynet+ system
supports Anynet+ devices only.
• Connect only one receiver (home theater).
• Check if the Anynet+ device power cord is properly connected.
• Check the Anynet + device's Video/Audio/HDMI 1.3 cable
connections.
• Check whetherAnynet + (HDMI-CEC) is set to On in the
Anynet + setup menu.
• Check whether the TV remote control is in TV mode.
• Check whether it is Anynet+ exclusive remote control.
• Anynet + doesn't work in certain situations. (Searching
channels, Operating, Plug & Play, etc.)
® When connecting or removing the HDMI 1.3 cable, please
make sure to search devices again or turn your TV off and on
again.
® Check if the Anynet + Function ofAnynet + device is set on.
® Check if the Anynet + device is properly connected to the
TV and check if the Anynet+ (HDMI-CEC) is set to On in the
Anynet + Setup menu.
® Press the TV button on the TV remote control to switch to TV.
Then press the TOOLS button to show the Anynet+ menu and
select a menu you want.
® Select View TV in the Anynet + menu.
® Press the SOURCE button on the TV remote control and select
a device other than Anynet + devices.
® Press v CH A, OH LIST, PRE-CH, and FAV.CHto change
the TV mode. (Note that the channel button operates only when
a tuner-embedded Anynet+ device is not connected.)
• You cannot use the remote control when you are configuring
Anynet + or switching to a view mode.
® Use the remote control when the Anynet + setting or switching
toview mode is complete.
® You cannot use the play function when Plug & Play is in
progress.
® Check whether or not the device supports Anynet+ functions.
® Check whether or not the HDMI 1.3 cable is properly
connected.
® Check whether Anynet+ (HDMI-CEC) is set to On in the
Anynet + setup menu.
® SearchAnynet + devices again.
® You can connect an Anynet + device using the HDMI 1.3 cable
only. Some Some HDMI cables may not support Anynet+
functions.
® If it is terminated by an abnormal situation such as
disconnecting the HDMI cable or power cord or a power failure,
please repeat the device scan.
® Check whether the antenna jack on the recording device is
properly connected.
® Connect the optical cable between TV and the receiver.
The TV program cannot
be recorded,
The TV sound is not
output through the
receiver,
I want to exit Anynet +.
The message Connecting
to Anynet + device,..
appears on the screen,
The Anynet + device does
not play.
The connected device is
not displayed,
I want to start Anynet+,
To Next Page
Loading...
