Disassembly and Reassembly _ 15
Part Figure Description
Thermistor
1. Remove the 2 screws.
Clutch (continued)
1. Separate the top cover assembly by lifting
and pushing ahead the top part of the
assembly.
2. .Remove the 2 screws holding the panel
control Separate all the wires connected to
the housing.
and separate the tub-cover.
4. Separate the pulsator-cap by inserting the
tip of a (-) screwdriver between the cover
rinse and the pulsator support.
5. Remove the bolt holding the pulsator with a
10mm wrench according to the direction of
arrow
Needtoextensiontoolfordisassemble
(Minlength:400mm)
To Next Page
Loading...
