11
GB
First Time Use
Initial Scan
When your radio is switched on from Standby for the rst time it will scan the DAB band,
searching for usable stations. These will be stored alphanumerically.
The initial scan will take a few minutes. While the scan is
running, the scan progress will be shown on a bargraph
and the number of stations found will be displayed.
When the scan nishes, the radio will play the rst
station in the sequence.
Note: If no stations are found, switch the radio o and
move it to a location with a stronger signal. When you
switch the radio back on it will automatically repeat the
scan process.
Setting the Clock Automatically
The time and date are set automatically from DAB station information.
Setting the Clock Manually
The clock can be set manually if there are no DAB stations in your area.
Manual clock settings will be updated when you next tune to a DAB station.
Basic Operation
Mode Select
• Press MODE repeatedly to switch between DAB, FM and Auxiliary Input modes.
Each mode will be displayed in turn.
Volume Control
• Turn the VOLUME dial to adjust the volume to the level you want.
The volume level will be displayed on a bargraph.
Scanning. . . .
28
S4DABB13E_IB_160920_will.indb 11 7/10/2016 3:36 PM
To Next Page
Loading...
Need help?
General
