20
GB
Setting the Alarm to Wake You
• Check that the alarm(s) is enabled.
• Set the radio to Standby.
Changing the Alarm Status:
To switch the alarms on or o when set to Standby -
• Press ALARM repeatedly.
The alarm status will change. There are four options
available to enable either or both alarms or to disable
both.
Make sure that you set the alarm volume level high
enough to wake you!
When the Alarm Sounds
To stop the alarm sounding:
• Press ALARM or to stop the alarm sounding.
To set Snooze mode:
• Press the SCROLL dial repeatedly to set a snooze
time of 5, 10, 15 or 30 minutes.
When Snooze mode is set the alarm will stop sounding for
the snooze period.
The alarm indicator will ash on the display and the
snooze time will count down.
When the snooze time expires the alarm will sound again.
• You can now set Snooze mode again or press to
cancel Snooze mode and switch the alarm o.
If you are unable to read the display at night, set the ‘Standby’ backlight brightness to a higher setting.
To briey switch on the display backlight to full brightness when set to Standby, press one of the buttons.
Snooze 4:13
Alarms 1: On
Alarms 2: Off
S4DABB13E_IB_160920_will.indb 20 7/10/2016 3:36 PM
To Next Page
Loading...
Need help?
General
