Polarization Control Unit PCU-110
4-1
Installation
4
・
Dangerous voltages, capable of causing injury or death, are present in this instrument.
Use extreme caution whenever the instrument covers are removed. Do not remove
the covers while the unit is plugged into a live outlet.
・
To avoid electric shock, the power cord protective ground conductor must be
connected to ground.
・
No user serviceable part exists in this instrument. Refer all services to qualied
personnel.
・
Before using this instrument, be sure to read through operation manual and data
sheets to ensure correct operations. Contact SANTEC to obtain service support
and do not install substitute parts or perform any unauthorized modications to this
instrument.
4-1 Warning and Caution
Pay attention to the following guidelines for safe, trouble-free operation.
This product is a high-precision device:
・
Do not place in direct sunlight.
・
Do not place under high temperature and high humidity.
・
Do not place in an environment with dust, dirt, salt, or corrosive gas.
・
Do not place in an area subject to large vibrations.
・
Do not place in an area subject to noise by electric eld, magnetic eld, etc.
・
Do not place in an area where the unit is subject to falling objects landing on it.
・
Do not place with possible exposure to water.
・
Do not place over a height of 2,000 meter.
Clearance of 5 cm at the rear side of the unit should be allowed for proper ventilation.
The PCU-110 weighs about 3.2 kg. Please ensure that the table or shelf upon which it
is installed has sufcient strength.
4-2 Operating environments
To Next Page
Loading...