4-2
PCU-110 Operation Manual
4-3 Power supply
This product uses a 3-line power cord and plug with a protective ground line.
Power cord may be attached and detached. Connect it to the power source socket at
the rear panel. Use the power cord supplied with the unit. Power Voltage is between
100 to 240 Volts, and 50 to 60Hz AC Line.
* Use two surge resistant type fuses. T1.6AL /250V (100 - 240V). The size of fuses is
5x20mm (Refer to section “7-3. Replacing Fuses").
CAUTION
This product is grounded by the ground line in the supplied power cable. This
product must be properly grounded to avoid electrical shock and other dangers.
Please make sure that this product is properly grounded to avoid electrical shock.
In addition, please place this product in a location that allows the user to easily
unplug the power cable, in case of any device malfunction.
4-4 Maximum safe input power
The maximum optical input power is +25dBm. Excess power input causes damage of
product.
To Next Page
Loading...