Thank you for purchasing a Santon PowerPack. The PowerPack unvented pressure
system water heater is manufactured to the highest standards and has been designed to
meet all the latest relevant safety specications.
This PowerPack water heater must be installed (Sections 3.0-6.0), commissioned
(Section 5.0) and maintained (Section 7.0) by a competent person. Please read and
understand these instructions prior to installing your PowerPack unvented pressure
system water heater. Particular attention should be paid to the section headed SAFETY
(Section 2.0).
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance by
a person responsible for their safety. Children should be supervised to ensure that they
do not play with the appliance.
CONNECTIONS
Inlet / Outlet connection -1/2” BSP
Water entry point - bottom
Cable entry point - bottom
ELECTRICAL
Model numbers
7.0kW - 94 050 211
9.0kW - 94 050 212
12.0kW - 94 050 213
Electrical rating... 6.4/7.0kW @ 230/240V
.............................8.2/9.0kW @ 230/240V
............................11.0/12.0kW @ 230/240V
PACK CONTENTS
Heater
Fixing screws and plugs
Expansion relief valve 1MPa (10bar)
Tee piece
Pressure relief valve (2.5bar for 7kW only)
Installation and User Instructions
TECHNICAL SPECIFICATION
INTRODUCTION
To Next Page
Loading...
