Sanyo FWZV475F - Page 30

30
EN
30
EN
BASIC RECORDING & ONE-TOUCH TIMER RECORDING
5
Press [C] to stop recording.
The recorded title will appear in the title list. (Refer
to “Guide to a Title List” on page 58.)
Writing to Disc 90%
•
This operation may take a while to be
completed.
4
Press [REC] to start recording.
“I” will be displayed for 4 seconds.
I
SP 2:00
Press [F] to pause recording.
Press [F]] or [REC] again to restart recording.
To set one-touch timer recording (OTR)...
This is a simple way to set the recording time in blocks
of 30 minutes.
Press [REC] repeatedly until the desired recording time
(30 minutes to 8 hours) appears on the TV screen.
One-touch timer recording will start.
0:30
(normal recording)
8:00
7:30
1:00
I
0:30
To change the recording length during the
one-touch timer recording:
Press [REC] repeatedly until the desired length appears.
To cancel the one-touch timer recording within the
specified time:
Press [C].
Note
•
When you press [REC], recording starts immediately and continues until the disc is full or you stop recording.
•
When the unit clock has not been set, the space for a date and time of title names will be blank.
•
You cannot change the recording mode during the recording pause mode.
•
You can change a channel (external input) to be recorded during the recording pause mode.
Note for one-touch timer recording
•
The remaining recording time will be displayed on the front panel display during one-touch timer recording. Press
[DISPLAY] to see it on the TV screen.
•
Unlike the timer recording, you can perform the following operations during one-touch timer recording.
- Turning the power to standby to stop one-touch timer recording.
- Using [REC] or [C] on the remote control.
•
You cannot use the pause function during one-touch timer recording.
•
If DVD one-touch timer recording is completed during VCR playback or recording, the DVD will be in stop mode and the
VCR keeps the current mode.
•
Whenone-touchtimerrecordingisnishedandthepoweristurnedtostandby,theunitwillswitchtothetimer-standby
mode automatically if a timer recording has been programmed. Press [TIMER SET] to cancel the timer-standby mode to
use the unit continuously.