SATELLITE LINK
8
Press [OK].
“To Standby Mode” is highlighted.
9
Press [OK] again.
Satellite Link
To Standby Mode
5:00PM DVD SP
Start Mode
DVD
VCR
In a second, the unit will be turned off
automatically as it goes into the satellite link
standby mode.
To cancel the satellite link function while in the
satellite link standby mode:
Press [TIMER SET] to turn on the unit.
To cancel the satellite link function while the
satellite link recording is in progress:
Press [C] on the front panel to stop the disc
recording.
Press [C A] on the front panel to stop the
cassette tape recording.
Notes
•
If the signal of external input breaks up over 5 seconds, satellite link function will be cancelled.
•
If you have not set the clock, “Clock Setting” menu will appear at step 4. Follow to step 4 in “SETTING THE CLOCK” on
page 26.
•
You cannot set the ending time for the satellite link timer recording on this unit.
•
Recording picture will be distorted if the copy protection signal is being detected during satellite link timer recording.
•
You can record the satellite link by using S-video input jacks on the rear panel. Refer to page 17 for more information.
•
When a regular timer recording and the satellite link timer recording are overlapped, those recordings are recorded as
illustrated below.
•
Press [TIMER] during the satellite link timer recording to check the satellite link timer recording in progress.
example 2
actual
recording
timer
recording
satellite link
example 3
actual
recording
timer
recording
satellite link
To Next Page
Loading...
