Sanyo ICR-EH800D - Connecting;disconnecting your PC; Connecting your PC

116
Connecting/disconnecting your PC
Connecting your PC
1
Slide out the USB terminal from the unit.
To slide out the USB terminal (page 13)
2
With the power turned off, connect the
USB terminal to your PC.
• If a bus-powered USB hub or USB extension
cable (not supplied cable) is used, the operation
will not be guaranteed. Therefore, always use
the dedicated USB extension cable for the
connection.
• When the unit is connected to your PC, it can
operate even if the battery is low.
Screen display during connection with PC
During file transfer, do not disconnect the unit from
your PC.
While the connection screen appears, all buttons
and switches on the unit are disabled.
The first time you connect the unit to your PC
Because multiple “Found New Hardware”
messages will appear, do not disconnect the unit
from your PC until all messages disappear.
• If nothing appears on your PC
(
page 120)


Becarefulwith
theinsertion
direction
Becarefulwith
theinsertion
direction