94
Using the VAS function
If the “VAS” (Voice Activated System) setting
is “ON” and the unit is ready for recording,
recording starts automatically when the unit
detects sound. When the sound drops below
a certain level, recording automatically
pauses (recording standby).
• VAS recording is not possible when the
“MIC ALC” setting is “OFF”.
• If the “VAS” setting is “ON”, the auto
power off function does not operate even
when the unit pauses during recording
(recording standby). However, if you
press the REC button (to pause) during
VAS recording, this is same as the pause
state in normal recording. (If the “AUTO
POWER OFF” setting is “ON”, the power
turns off after the specified time elapses.)
• You cannot change the “VAS” setting
during line-in recording.
• Because small sound may not be
recorded, turn off the VAS function for
important recording.
• If the “LOW CUT FILTER” setting is “ON”,
low frequency sound may be cut out and
recording may not activate. In this case,
change the “LOW CUT FILTER” setting to
“OFF”.
1
Turn on the power, and press
the MENU/PLAY LIST button.
2
Press the VOL (+/–) button to
select “REC MENU”, and then
press the
/OK button.
3
Press the VOL (+/–) button to
select the “VAS” setting, and
then press the
/OK button.
4
Press the VOL (+/–) button to
select “OFF” or “ON”, and then
press the
/OK button.
To Next Page
Loading...
