Sanyo ICR-EH800D - Page 95

95
From the basic screen, press the
REC button.
When the unit detects sound, it starts
recording automatically. When it cannot
detect sound, it pauses (recording standby);
the elapsed time and the VAS indicator
flash.
• Pressing the STOP/BACK button stops
recording.

Adjusting the sound detection
level
If the “VAS” setting is “ON”, you can press
the
/ button during recording to
adjust the sound detection level.
VAS
PCM 44.1K
9$6
MIC
ST
A
SD
10
45
1
m
h
s
Sounddetection
level
• You can adjust the sound detection level
from 1 to 5 . (When shipped, the unit is
set to 3 in its sound detection level.)
• If the level is set to a larger number, small
sound can be detected and so recording
starts. In a place with a lot of noises,
recording may not pause.
