Sanyo ICR-EH800D - Remaining Battery Power; Resume Function

23
Remaining battery power
You can check the remaining battery power from the screen. When
appears, replace as soon as possible with a new battery.
• When the battery is low, “LOW BATTERY PLEASE CHANGE THE
BATTERY” appears and then the screen goes off.
• When the battery is low, if the “BEEP SOUND” setting is set to “ON”,
you can hear a beep sound.
• Depending on the ambient temperature and usage, the battery duration
may change. Therefore, take the battery indicator as a rough guide.
• Once the alkaline battery is low, do not continue to use the alkaline
battery. For an eneloop battery, recharge it sufficiently before using it again.
Resume function
The resume function remembers file used and playback position before the power was
turned off last time. When you turn on the power again, the unit resumes with these settings.
However, the resume function does not work in the following cases.
- If you switch the folder
- If the unit is connected to your PC
- If you remove the battery or a microSD card without turning off the power first
- If you switch between the internal memory and a microSD card
RECREMAINTIME
00
00
0
00
16
m
h
s
m s
ST
FLAT
A
MP3 128k
0/0
MIC
SD
A
Batterypower
Small
Large
RECREMAINTIME
00
00
0
00
16
m
h
s
m s
ST
FLAT
A
MP3 128k
0/0
MIC
SD
A
Batterypower
Small
Large