Sanyo ICR-EH800D - Page 37

37
• In the range where the recording LED
does not light up, try as much as possible
to increase the recording level (level meter
extending to the right) by pressing the
button.
• If the recording LED lights, press the
button to slightly lower the recording level until
the recording LED goes off.
• If the recording LED still lights after you have
dropped the recording level to 1, change the
“MIC SENS.” setting to “LOW”.
If the level meter does not reach an
appropriate recording level after you have
increased the recording level to 30, change
the “MIC SENS.” setting to “HIGH”.
Changing the microphone sensitivity
(page 88)
• An appropriate recording level is when even
you increase the sound you want to record to
its maximum, the level meter does not extend
to the right and the recording LED does not
light.
* If the “REC LED” setting is set to “OFF”, the
recording LED does not light.
Turning on/off the recording LED (page
106)
MicLevel4
10
45
1
m
h
s
Iftherecording
levelistoolow
4
44.1K
MIC
PCM
A
SD
ST
MicLevel4
10
45
1
m
h
s
Iftherecording
levelistoolow
4
44.1K
MIC
PCM
A
SD
ST
MicLevel30
10
45
1
m
h
s
Iftherecording
levelistoohigh
30
44.1K
MIC
PCM
A
SD
ST
MicLevel30
10
45
1
m
h
s
Iftherecording
levelistoohigh
30
44.1K
MIC
PCM
A
SD
ST
RECLEDRECLED
MicLevel15
10
45
1
m
h
s
15
44.1K
MIC
PCM
A
SD
ST
Appropriate
recordinglevel
MicLevel15
10
45
1
m
h
s
15
44.1K
MIC
PCM
A
SD
ST
Appropriate
recordinglevel