Sanyo MS6A - Page 15

-15-
1 Remove 2 screws A and pull the Condenser Lens ass’y upward.
2 Remove 4 screws B to take the Lens off from the holder.
1 Remove 2 screws A and pull the Condenser Lens-Out ass’y upward.
2 Remove 2 screws B to take the Lens off from the holder.
Note:
Should be place the lens as shown in the figure.
A
Optical Pats Disassemblies
B
Condenser Lens
Fig.3-2
Fig.3-1
* Should be place the lens as the
flat surface side comes to the
holder side.
Holder
A
A
Fig.4-
2
Fig.4-1
B
B
Holder
Condenser Lens-Out
A
Condenser lens disassembly
Condenser Lens-Out disassembly
B
B
B
Side View