Sanyo MS6A - Mechanical Disassemblies

1 Remove 1 screw A and take a Washer, Spring and
Interlock Switch lever.
2 Pull the Fan and duct ass’y upward, then remove the
2 screws B to take the Fan (FN906) off.
-13-
Mechanical Disassemblies
Fig.10
1 Remove 1 screw A to take the Temp. Board off.
2 Remove 8 screws B and to take the Fan Duct
Top off and remove the Fans (FN902, FN903,
FN904).
3 Remove 4 screws C to take the Fan Duct Bottom
off from the Cabinet Bottom.
Fig.11
Fan (FN905) removal
10
Temp Board and Fans (FN902, FN903, FN904) removal
11
Interlock switch lever
A
B
B
FN905
A
B
B
B
B
B
B
B
C
C
C
C
FN904
FN903
FN902
Temp board
Fan duct top