-14-
1 Remove the Front Panel following to “Front Panel Removal” on “Mechanical
Disassemblies”.
2 Remove 4 screws to take the Projection Lens ass’y off.
1 Remove 2 screws A and pull the Integrator Lens-In ass’y upward.
2 Remove 1 stopper B and then take the Lens off from the holder.
Fig.1
■ Optical Parts Disassemblies
Before taking this procedure, remove Cabinet Top and Main Board following to the “Mechanical Disassemblies”.
Disassembly requires a 2.0mm hex wrench and a screwdriver.
Integrator Lens
* Should be placed the lens as
the rugged surface side of it
comes to the holder side.
Fig.2-
1
Fig.2-2
Projection Lens removal
Integrator Lens-In disassembly
Stopper B
A
A
To Next Page
Loading...
