Sanyo PLC-WTC500AL - Setting: Lamp Management; Lamp Mode Selection

53
Setting
This Projector is equipped with 2 Projection Lamps. This
function allows you to choose how to use the lamp as follows.
Lamp1............ Always use Lamp 1.
Lamp2 ........... Always use Lamp 2.
Lamp1/2......... Automatically switch the active lamp from one
lamp to the other .
✔Note:
 •WhenLamp1orLamp2modeisswitchedtoLamp
1/2mode,theactivelampchangesafterthetotal
lightingtimeofacurrentlyusedlampexceeds10
hours.
 •Whenthetotallightingtimeofonelampexceeds
therecommendedtotalhoursofuseintheLamp1/2
mode,theLampmodewillbeswitchedtoLamp1or
Lamp2modeautomatically.Switchingoperationis
donewhenthelampischanged.
 •Lampmodecannotbechangedforawhileafter
turningontheprojector.Lampneedssometimeto
stabilizeafterthepoweristurnedon.Storedlamp
modewillbeactiveafterthelampisstabilized.
•Whenthedifferentlightingtimeofthelampslight
alternately,youmayrecognizedifferentbrightness
andwhitebalanceoneachdifferentlightingtimeof
lamps.
  Whenyouchangetheotherlamp,werecommend
youalwaysusetheotherlampwhichisnotchanged.
 •WhentheTimerissetto“Off”andthetotallighting
timeofonelampexceeds10hoursofuseinthe
Lamp1/2mode,onelampwillbeswitchedtothe
otherlampautomatically.Switchingoperationis
donewhentheprojectoristurnedOffandOn.
 •WhentheprojectorisswitchedtoOff/On(including
Standby),Timersettingisresettooff.
 •WhentheTimerissetto“On”intheLamp1/2mode,
  theLamptimercounterisdisplayedontherightside
oftheLampmodeintheInformationmenu.(p.30)
Set the red frame pointer
to the item and press the
SELECT button.
Use the Point
ed buttons
to set the Lamp mode.
Select from (Lamp1,Lamp2or
Lamp1/2).
Select [Yes] to
activate it.
Lamp mode
The following items can be selected.
Timer setting :
............Switch the timer to On/Off.
Start .........Time to start timer.
(0-24 hours)
Lamp interval . .Time to lamp change.
(1-24 hours)
When selecting Lamp1/2 mode
Use the Point 7 8 buttons to
select items and press the
SELECT buttons.
Select [Yes] to
activate it.
✔Note:
  •The Lamp timer counter appears with
the Lamp status before 10 seconds
when the Lamp will be switched.
Timer setting