Sanyo PLC-WTC500AL - Setting: Lamp and Filter Control; Lamp Control (Brightness and Life); Filter Control and Replacement

54
Setting
Lamp control
This function allows you to change brightness of the screen.
Auto 1 .........The brightness according to the input signal
(between Normal and Eco mode).
Auto 2 ......... The brightness according to the input signal
(between High and Eco mode).
High ............ Brighter than the Normal mode.
Normal ....... Normal brightness
Eco 1 ..........
Lower brightness and Fan speed decrease.
Lower brightness reduces the lamp power
consumption and extends the lamp life.
Eco 2 .......... Lower brightness and Fan speed increase.
Lower brightness reduces the lamp power
consumption and extends the lamp life. It is
recommended to use Eco 2 when using the
projector continuously over a long period of
time.
Lamp control
Lamp life control
Select the lamp operation when the total lighting time of a lamp
exceeds the recommended total hours of use.
Mode 1 ............ A lamp can be turned on even after exceeding
the recommended total hours of use.
Mode 2 ...... A lamp is not turned on after exceeding the
recommended total hours of use.
✔Note:
 •Alampisswitchedtothelampwhich
isnotexceedingtherecommended
totalhoursofusenexttimewhen
youturnontheprojector,evenwhen
theMode1isselected.
✔Note:
 •ThefannoisebecomeslouderinEco
2thaninEco1.Selectthesuitable
modefortheusedenvironment.
Filter control
You can replace the filter with this function. Press the
SELECT button at Filter control to display a confirmation
box. To replace, press the SELECT button at “YES” and the
electrically operated filter starts to scroll.
✔Note:
 •Filterreplacementiconand“Please
wait...”messageappearonthescreen
whenthefilterisbeingscrolled.
 •Thefiltercannotberewound.
 •Whenthefilterisreplaced,thetotal
accumulatedtimeofthefilteruseis
automaticallysetto0.