Sanyo PLC-XF47 - Basic Operation Guide; Projector Power On and Off Procedures

- 23 -
B
B
C
C
C
D
A
A
D
4-3
Terminal Slot units disassemblies.
1. Remove 2 screws-A and remove the Lamp net Board.
2. Remove 2 screws-B and remove the Holder-B.
3. Remove 3 screws-C, remove the Holder-A and remove the CG Mother Board.
4. Remove 2 screws-D, remove 2 washeres and remove Grounding Leads from the CG Mother Board.
Mechanical disassemblies
Holder-B
Lamp Net Board
Grounding lead
Grounding lead
CG Mother Board
Panel
4-4
Control Switch unit disassemblies.
1. Remove 4 screws, remove the Control Button and remove the Control Board.
Control Panel
Control Button
Control Board