Sanyo PLC-XF47 - Selecting Video Input Sources

A
A
A
A
A
A
B
B
B
B
B
B
C
C
D
D
D
D
E
E
E
C
C
F
1. Remove 6 screws-A and remove the Adjustable-foot-left.
2. Remove 6 screws-B and remove the Adjustable-foot-right.
3. Remove 2 screws-C and remove the Fan(FN906) Unit.
4. Remove 4 screws-D and remove the Fan(FN906).
5. Remove 3 screws-E and remove the Rear LED Board.
6. Remove screw-F and remove the PWB Holder.
- 32 -
B
B
B
B
A
A
A
A
A
A
A
A
A
A
6
Optical Unit removal.
1. Remove 9 screws-A, remove 4 screws-B and remove the Optical
unit.
Warning;
Do not hold the projection lens.
It may damage projection lens.
7-1
Fan(FN906) Unit and Adjustable-feet removal.
Mechanical disassemblies
Warning!
Do not hold the Projection lens
This screw has been
removed in step 5-4.
Note;
Mark the Fans as they are removed from the holder so that
they may be reassembled in the same location from which
they were removed. Be careful of the attached direction of
Fans.
See arrow mark in a figure.
Optical unit
Rear LED Board
PWB Holder
Holder Fan
The direction of a
wind. (FN906)
Fan (FN906) unit
Adjustable
foot-left
Adjustable
foot-right