Sanyo PLC-XF47 - Computer Input Settings; Automatic and Manual Computer System Setup

- 33 -
A
A
A
D
D
D
D
B
B
C
C
F
F
F F
F
F
G
H
H
I
I
J
J
L
L
7-2
Fan Units removal and disassemblies.
Fan(R) Unit removal and Disassemblies.
1. Remove 3 screws-A and remove the Fan(R) Unit.
2. Remove 2 screws-B and remove the Duct-A.
3. Remove 2 screws-C and remove the Fan(FN903).
Fans(G,B) UNIT removal and Disassemblies.
4. Remove 4 screws-D and remove the Fan (G,B) Unit.
5. Remove 6 screws-F and remove the Duct-C.
6. Remove screw-G and remove the Sensor Board.
7. Remove 2 screws-H and remove the Fan (FN905).
8. Remove 2 screws-I and remove the Fan (FN916).
9. Remove 2 screws-J and remove the Fan (FN904).
10. Remove 2 screws-L and remove the RGB in Fan net Board.
Note :
Mark the Fans as they are removed from the duct so that
they may be reassembled in the same location from
which they were removed.
Mechanical disassemblies
RGB IN Fan net Board
Duct-D
Duct-C
FN904
FN916
FN905
Sensor
Board
Duct-B
Duct-A
FN903
Fans (B, G)
unit
Fan (R) unit