Sanyo PLC-XF47 - Page 43

- 43 -
Integrator lens-in unit removal.
1. Remove 2 screws A and remove the Integrator lens in unit.
2. Remove 4 screws B and remove the 2 Plates.
3. Unhook the holder 4 places and remove the Integrator lens. (Integrator lens is bonded on the Holder.)
B
B
B
B
A
A
13-1
Integrator lens
Inunit
Slot part comes this top side
A
A
A
B
B
B
B
13-2
Integrator lens-out / PBS unit removal.
1. Remove 3 screws-A and remove the Integrator lens out / PBS unit.
2. Remove 4 screws-B, remove the 2 Plates and remove the PBS.
3. Unhook the holder 4 places and remove the Integrator lens. (Integrator lens and PBS are bonded on the Holder.)
Optical Unit disassemblies
Plate
Plate
Holder
Integrator
lens IN
Rugged surface
Unhook
Unhook
Unhook
Unhook
Lens should be placed as the rugged
surface side comes to the holder side.
Lens bonded on the holder.
Unhook
Unhook
Unhook
Unhook
Rugged
surface
Slot part comes this top side
Integrator
lens OUT
Integrator lens OUT/
PBS unit
Plate
Plate
PBS
Holder
Film attached side comes to the this side.