Sanyo PLC-XL50A - Page 60

- 60 -
Service Adjustment
Group/
Item
Item Name Function Initial Range Note
8 CB - GAIN AREA H START 800 0 - 1000
9 CB - GAIN AREA V START 500 0 - 1000
10 CR - GAIN AREA H START 700 0 - 1000
11 CR - GAIN AREA V START 500 0 - 1000
12 Image AREA H WIDTH YCBCR Level Acquiring Area 13 0 - 4095
13 Image AREA V HIGHT YCBCR Level Acquiring Area Height 9 0 - 4095
14 Y - OFFSET TARTGET 4 0 - 255
15 CB OFFSET TARGET 128 0 - 255
16 CR OFFSET TARGET 128 0 - 255
17 Y - GAIN TARGET 217 0 - 255
18 CB - GAIN TARGET 237 0 - 255
19 CR - GAIN TARGET 237 0 - 255
20 OFFSET torelance Torelance of OFFSET Adj. 1 1 - 255
21 GAIN torelance Torelance of GAIN Adj. 1 1 - 255
Group 270 CUSTUM (Aspect)
0 Scaler Horizontal
Horizontal Expansion and
contraction rate
100 68 - 132
1 Scaler Vertical
vertical Expansion and contraction
rate
100 68 - 132
2 Connect Select Individual / synchronizatio 0 0 - 1 0 : Individual 1 : synchronizatio
3 Position Horizontal Revise Horizontal Position 100 85 - 115
4 Position Vertical Revise Vertical Position 100 85 - 115
Group 280 AutoPC Adjsut
0 AutoPCAdjustEnable
Auto-PC Adj Operation Enable if Un-
supported Signal Input
0 0 - 1 0: Enable, 1: Disable
1 Frequency Step Frequency Steps of TotalDot 1 0 - 3
2 Frequency Threshold Total Dot Freqency Threshold 5 0 - 10 0 [] <--- -----> 10[Not matched]
3 Fine Phase Do Phase Adj after Total Dot Adj. 1 0 - 1 0: Executes Fine Phase, 1: Not Execute
4 BLKDET Black Level Detection Area 1 0 - 7
5 PHASEMSK Phase Detection Filter 0 0 - 3
0: Eective All Bit,
1: Disable Lower 1 bit
2: Disable Lower 2 bit, 3: Disable Lower
3 bit
Group 290 PanelType * Panel Type Check
0 GammaL/R-View Current Setting Check 0 0-20
0: Gamma for L-Turn
20: Gamma for R-Turn * Read only
1 GammaL/R-Change Setting of Gamma 10 0-20
Sets L-Turn Gamma if the Value is set
to 0.
Sets R-Turn Gamma if the Value is set
to 20.
Group 500 Composite (NTSC) Composite / S-Video
0 Total Dots Read only
1 Disp Dots 668 0 ~ 4095
2 H Back Porch 28 0 ~ 4095
3 V Back Porch 18 0 ~ 4095
4 Disp Line 458 0 ~ 4095
7 Overscan Not used 0 0 - 255
8 VSBEG Not used 2 0 - 15
Group 501 Composite (PAL) Composite / S-Video
0 Total Dots Read only
1 Disp Dots 658 0 ~ 4095
2 H Back Porch 34 0 ~ 4095
3 V Back Porch 22 0 ~ 4095
4 Disp Line 536 0 ~ 4095
Group 502 Composite (SECAM) Composite / S-Video
0 Total Dots Read only
1 Disp Dots 652 0 ~ 4095
2 H Back Porch 28 0 ~ 4095
3 V Back Porch 22 0 ~ 4095
4 Disp Line 536 0 ~ 4095
Group 510 SCART(480i)
0 Total Dots Read only
1 Disp Dots 662 0 ~ 4095
2 H Back Porch 142 0 ~ 4095