To Next PageTo Next PageWhy is the LAMP REPLACE indicator lighting yellow on my Sanyo Projector?
If the LAMP REPLACE indicator lights yellow, promptly replace the projection lamp with a new one. After replacing the lamp, remember to reset the lamp replacement counter.
What to do if the temperature of my Sanyo PLC-XU101 Projector is abnormally high?
If the projector temperature is abnormally high, it will need to cool down. Once the temperature returns to normal, the POWER indicator will emit a red light, and the projector can be turned on. The WARNING indicator will keep blinking. Also, check and clean the air filter.
What to do if my Sanyo Projector detects an abnormal condition and cannot be turned on?
If your projector detects an abnormal condition and cannot be turned on, check the power supply circuit and fans control circuit.
What to do if my Sanyo Projector has been cooled down enough and the temperature returns to normal?
When turning on the projector, the WARNING indicator stops blinking. Check and clean the air filter.
How to fix a Sanyo PLC-XU101 that is off?
The AC power cord may be unplugged. Ensure the AC power cord is properly connected.
General| Matrix size | 0.8 \ |
|---|---|
| Vertical scan range | 50 - 100 Hz |
| Horizontal scan range | 15 - 100 kHz |
| Projection technology | LCD |
| Contrast ratio (typical) | 500:1 |
| Screen size compatibility | 33 - 300 \ |
| Projector native resolution | XGA (1024x768) |
| Keystone correction, vertical | ±40 ° |
| Output | D-Sub15 x 1 |
| Video in | RCA x 1 |
| Audio input | Yes |
| Aspect ratio | 4:3 |
| Dimensions (WxDxH) | 334 x 232 x 78 mm |
| Connectivity technology | Wired |
| Lamp power | 275 W |
| Light source type | Lamp |
| Noise level | 29 dB |
| Dot clock scanning frequency | 140 MHz |
| Audio (L/R) in | 2 |
| Headphone outputs | 1 |
| Display resolution | 786 x 432 pixels |
| Power consumption (typical) | 385 W |
Weight and Dimensions| Weight | 3500 g |
|---|
