EasyManuals Logo

Sanyo PLC-XU101 Service Manual

Sanyo PLC-XU101
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
-55-
Troubleshooting
No Sound
Check IC5001 and peripheral circuit.
Check 5V_AUDIO, 9V power supply.
Check if the audio sig-
nal is observed at pins
10 and 21 of IC5001.
Check audio output circuit.
Check speaker, connection of the terminal “K8F”
Yes
No
Check following steps.
Check IC5031, 5V_AUDIO and peripheral circuit.
Check the Mute signal at pin 1 of IC5031. The Mute signal is output from
pin 92 of IC 301<Scaler>. The OUT_DET signal is sent from Audio Out
terminal.
Mute-On: H at pin 347 of IC301, L at pin1 of IC5031
Check if the audio sig-
nal is observed at pins 5
and 8 of IC5031.
Yes
No

Table of Contents

Other manuals for Sanyo PLC-XU101

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-XU101 and is the answer not in the manual?

Sanyo PLC-XU101 Specifications

General IconGeneral
Matrix size0.8 \
Vertical scan range50 - 100 Hz
Horizontal scan range15 - 100 kHz
Projection technologyLCD
Contrast ratio (typical)500:1
Screen size compatibility33 - 300 \
Projector native resolutionXGA (1024x768)
Keystone correction, vertical±40 °
OutputD-Sub15 x 1
Video inRCA x 1
Audio inputYes
Aspect ratio4:3
Dimensions (WxDxH)334 x 232 x 78 mm
Connectivity technologyWired
Lamp power275 W
Light source typeLamp
Noise level29 dB
Dot clock scanning frequency140 MHz
Audio (L/R) in2
Headphone outputs1
Display resolution786 x 432 pixels
Power consumption (typical)385 W
Weight and Dimensions IconWeight and Dimensions
Weight3500 g

Related product manuals